G29 L0 A Load and Activate the UBL mesh in Specified Slot M104 S180 Warm Extruder just below operating temp Also added Software Version to the bug description I have utter contempt for the one scratching my bed though):Ĩ0C Bed after 30 minutes heating up - triggered manuallyĨ0C bed taken a few minutes after the one shown above - This one was done as part of the startup code in a print fileĮDIT: Replaced the links with uploaded pictures for easier viewing. I'll let the pictures speak for themselves here (The results for manual trigger are about what is expected. There should be no difference triggering it manually vs during a print as pre-printing gcode. G29 J should be very close to identical between subsequent runs of itself. Software version 2.0.5.3 My ConfigurationsĮxpected behavior: G29 J has wildly different results from when I initiate it via a print and when I trigger it manually.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |